stress relieved
英 [stres rɪˈliːvd]
美 [stres rɪˈliːvd]
网络 应力清除
双语例句
- The procedure is also recommended for many patients who have poor blood flow to the heart during periods of exercise or stress that is not relieved by rest or drugs.
对于那些在运动或应激时心脏血供较差且不能通过休息或药物来缓解的病人，这种治疗也被推荐。 - Was this stuff stress relieved? Was it, when they fabricated this particular nozzle, this particular piece, was it highly stressed when they assembled it?
是材料了应力消失了吗，是它吗，当他们知道这个特殊的管嘴时，这个特殊的管嘴，它是高度受压的吗，当他们装配的时候？ - The part of thermal stress is relieved and the residual stress of phase changing is descend.
消除部分热应力和相变应力，残余应力也有所降低。 - The residual stress will produce in weldments and other construction parts during the manufacturing process and will harm their dimension stability and service life, and therefore must be relieved.
焊接件等结构件在制造过程中会产生残余应力，影响其尺寸稳定性和使用寿命，因此必须消除。 - Based on the analytical solution to stress field around a hole in a stressed orthotropic infinite width plate, a set of equations was derived to calculate the relieved strain matrix.
以正交各向异性无限大板孔边应力场解析解为基础，导出了释放应变矩阵计算表达式，并用一个算例验证了该计算式的正确性。 - Results The total effective rate was 84.18%. The psychological problems of 766 patients were significant resolved and their relatives 'stress was relieved.
结果治疗性沟通技巧可提高病人的心理健康水平，总有效率达84.18%，766例病人的心理问题得到明显改善，能积极配合医护人员或安详地离开人间。 - By introducing the PLLA cushion, the stiffness of the plate fixation may decrease and then the stress shielding effects of the plate to the bone tissue may be relieved.
通过可降解PLLA衬垫的引入，降低接骨板系统的刚度，从而减轻接骨板对骨组织的应力遮挡效应。 - The value of strength revisionary term decreases as temperature increases, inflecting that the residual stress is relieved partly at elevated temperatures.
高温下强度修正项的值随温度的升高而减小，说明残余应力在高温作用下得到了部分消除； - When a high level isotropic stress field is disturbed by a drilled hole, a relation of relieved strain vs. residual stress is derived by the basic equations of elasto-plastic theory.
本文根据弹塑性理论基本方程，导出了高水平均匀残余应力场由于钻孔引起的松弛应变与残余应力的关系公式。 - Conclusion: Stress response can be relieved by epidural anesthesia in patients undergoing thoracic operation.
结论：硬膜外腔阻滞可以减轻胸部手术的应激反应。 - The interface peak of stretching stress of phase changing is relieved, and satisfaction of stress status of cladding layer is obtained.
界面的相变拉应力峰被消除，得到了应力分布状态较好的激光熔覆层。 - After the water stress was relieved, the decline range of enzyme vigor for the treatment of SE was lower than that for the one of the control.
当水分胁迫解除后，海藻液肥处理酶活力的下降幅度低于对照。 - The results showed that for molybdenum steel residual welding stress can be relieved by 67% with temper heat teatment method, which can be relieved by 94% with normalizing and temper heat treatment method.
结果表明：对含钼钢材来说，回火热处理仅可消除67%的残余应力，正火加回火的热处理方法消除焊接残余应力可达94%。 - Operation stress could be relieved by nursing intervention.
手术应激反应是可以通过各种护理干预减轻的。 - Considering the characteristics of hydrogen stress corrosion, a restoration plan was made especially in weld preheating, post-weld heat treatment, welding rod and plate selection. Therefore, the hardness of the welding seam and heat-affected zone was reduced and residual stress was relieved.
结合氢应力腐蚀特点制定了修复方案，特别是焊前预热、焊后热处理、选择合适的焊条及板材，降低了焊道和热影响区硬度，消除残余应力。 - The maximal equivalent stress effectively relieved when the thickness of pure W and gradient layer was 2 mm and 240 μ m, respectively.
钨涂层表面层厚度为2mm，梯度层为240μm时，最大等效应力得到有效的缓解。 - Under both operation pressure and temperature, the stresses redistributed, and the inner layer stress state relieved, but the weld toe was still the most stress concentrated area.
在内压力和温度共同作用下时，应力重新分布，内衬层的应力得到缓解，应力最集中的部位仍是层间隙焊趾处。 - If drought stress to them is not above the threshold, drought effect can be relieved by water supplement.
植物受干旱胁迫如果未超过其耐受阈值，则补水能较大程度减轻其受干旱的影响。 - When stress was relieved, the seeds still have a high germination ability and vitality.
胁迫解除后，种子仍具有较高的发芽力和活力。 - Numerical simulations to on different locations of the stress highly concentrated coal-lane are relieved by means of two simulation softwares, which are RFPA and FLAC, to determine the reasonable position of relieving lane and show the correctness of the tendency of coal-bearing pressure distribution.
采用RFPA和FLAC两种数值模拟软件对应力高度集中煤柱的卸压巷进行了不同位置数值模拟，确定了卸压巷的合理位置，同时还验证了该煤柱倾向支承压力分布的正确性。